Houston Plumber - Expert plumbers for slab leak repair in Houston
Excavation and Replacement
This is the most invasive and expensive option, but it may be necessary if the leak is located in a difficult to reach spot or if the damage is extensive. The process involves excavating the area around the leak, repairing or replacing the pipe, and then filling in and sealing the hole. This option is often used when the pipe is located beneath a concrete foundation or other hard surface.
Pipe Lining
This is a less invasive option that can be used to repair small leaks or those that are located in accessible areas. A new pipe is inserted into the old one and inflated, which creates a seal. This option can be used for sewer lines, storm drains, and water mains.
Pipe Bursting
This method is used to replace an old, damaged pipe with a new one. A machine is used to break up the old pipe while a new pipe is pulled through the same route. This is a good option for sewer lines and water mains that are in bad condition.
Trenchless Pipe Repair
This is a newer method that uses minimal digging to repair or replace pipes. A small access point is made and a camera is inserted into the pipe to assess the damage. If the damage is minor, a liner can be inserted to repair the pipe.
How do I know if I have a slab leak?
There are several ways that you may be able to tell if you have a slab leak. You may hear water running or dripping even when all of your taps are turned off. You may notice unexplained increases in your water bill. Or, you may see standing water or dampness on your floors or walls. If you suspect that you have a slab leak, it is important to contact a professional right away to have it repaired.
What causes slab leaks?
There are several potential causes of slab leaks. One common cause is damage to the pipes due to shifting or settling of the foundation. Another common cause is corrosion of the pipes due to contact with chemicals in the soil. Additionally, leaks can occur if the pipes are not installed properly or if they are damaged during construction.
How do you repair a slab leak?
The first step in repairing a slab leak is to locate the source of the leak. Once the leak is located, the next step is to determine the best way to repair it. This will depend on the severity of the leak and the type of pipe that is leaking. In some cases, a simple patch may be all that is needed. In other cases, the entire section of pipe may need to be replaced.
